Redmine

05.02.2026

18:48 Helios Fehler #729 (Neu): On button press when alarm is running, device switches to normal run mode

Device should switch off.
When recreating it directly, everything works as expected. Need some logs. Maximilian Seesslen

18:46 Helios Fehler #721 (Erledigt): Interrupt inactive when device is started

Maximilian Seesslen

02.02.2026

13:03 Bamboo Feature #728 (Neu): Test magic keys

Ich muesste Kupferklebeband haben. Einfach testen. Maximilian Seesslen

24.01.2026

16:41 ESP32 Fehler #725: [SN1] Enable pin pulled low

C5 caused an shortcut. Maximilian Seesslen

23.01.2026

20:06 ESP32 Fehler #725 (Neu): [SN1] Enable pin pulled low

Enable->GND: 0,2 Ohm, open on unsoldered PCB
Maximilian Seesslen

07.01.2026

11:20 Helios Fehler #720: Eval-RTC: Strange behaviour when battery gets removed

Is there really a voltage feed back when battery is removed? That would be not intended. Maximilian Seesslen

11:13 Helios Fehler #722 (Neu): Resistor between BAT and "Enable" is way too high

The LED pulls it down so it will not be accepted by the MAX Chip.
There is barely a use for this resistor anyways.
Maximilian Seesslen

10:28 Helios Fehler #721 (Erledigt): Interrupt inactive when device is started

When the device is powered on and alarm is not set, the alarm will not raise an interrupt. This will cause the device... Maximilian Seesslen