Steps » Historie » Revision 2
Revision 1 (Maximilian Seesslen, 09.07.2025 15:17) → Revision 2/9 (Maximilian Seesslen, 09.07.2025 15:28)
h1. Steps
* -Design Design Eval PCB- PCB
* produce EVAL PCB
* Produce firmware/Setup to wake STM32 up. An additional PCB my be needed with switch and LED. Without an PCB just an LED can be driven.
* min Drop-out in buck-mode not known. Measure Voltage with existing modules.
* -Design Design Eval PCB- PCB
* produce EVAL PCB
* Produce firmware/Setup to wake STM32 up. An additional PCB my be needed with switch and LED. Without an PCB just an LED can be driven.
* min Drop-out in buck-mode not known. Measure Voltage with existing modules.