Steps » Historie » Revision 3
Revision 2 (Maximilian Seesslen, 09.07.2025 15:28) → Revision 3/9 (Maximilian Seesslen, 16.07.2025 11:58)
h1. Steps
* -Design Eval PCB-
* Order STM32F072
* Solder produce EVAL PCB
* Order pin header for LED drivers
* Produce firmware/Setup to wake STM32 up. An additional PCB may my be needed with switch and LED. Without an PCB just an LED can be driven.
* min Drop-out in buck-mode of LED drivers not known. Measure Voltage with existing modules.
* Design real PCB
* -Design Eval PCB-
* Order STM32F072
* Solder produce EVAL PCB
* Order pin header for LED drivers
* Produce firmware/Setup to wake STM32 up. An additional PCB may my be needed with switch and LED. Without an PCB just an LED can be driven.
* min Drop-out in buck-mode of LED drivers not known. Measure Voltage with existing modules.
* Design real PCB